HOW TO INSTALL PAPER-FACED GLASS MOSAIC TILES
Step 1: Apply Thinset
Start by applying white thinset to the walls with a V-notched trowel. Remember to be careful when choosing the color of your thinset. When working with glass tile, you will be able to see through the tile, so you will want to choose a color that works with the design of the room.
Tip: You will see through the glass tile, so be sure to start with a clean and uniform-colored wall. Pencil marks will show through!
HOW TO INSTALL A HOT TUB ON A DECK
Step 1: Set the Tub in Position
Once the frames are complete and the joists are in place, carefully position and set the hot tub in the inner frame (see below).
Step 2: Add the Access Panel
Measure the width of the hot tub's access panel (Image 1). This will be the width of the access panel door. Cut several 2x4 beams to the width of the access panel. Lay the beams next to each other and make sure they are flush along the edges. Then, screw two 2x4s across the beams to keep them together. Once the access panel door is screwed together, set it in place in front of the hot tub access panel (see below).
HOW TO MAKE A TEMPORARY WORK TABLE
Posted: April 4th, 2014 by Admin
Step 1: Cut the Plywood
Cut a piece of plywood for the table top no larger than 4' x 4', any larger and the table would sag. The table can be any shape desired.
Step 2: Attach the Clamps
Get four clamps of the same size (see below). Use either pipe clamps or standard bar clamps as long as they are a good length for substitution as table legs.
Attach a bar clamp to each corner of a piece of plywood. Once the clamps are in place, spread them out a little bit to add a little more stability.
